GoDEX Printer Settings for Check-In (DT4, DT4x, DT4xW)
======================================================

Before you use Check-In for the first time
after installing the software,
you will need to configure your printer settings
for the size labels you are using.
Depending on your computer,
these screenshots may appear a bit different for you,
but the settings should be basically the same.

.. seealso::
    :doc:`/Checkin/CheckInPrintServer`

Step 1
    Find the `GoDEX printer` on the Check-In PC.
    Go to `Start > Printers and Devices`.
Step 2
    Right-click on the `GoDEX printer` and select `Printing Preferences`.

    .. figure:: https://i.tpsdb.com/hope.1212141140.PrinterPreferences.jpeg
        :target: #

Step 3
    On the `Page Setup` tab, click `New`.

    .. figure:: https://i.tpsdb.com/hope.1212141142.PageSetup.jpeg
        :target: #

    This will open the dialog box
    for you to edit the Stock for the new label.
    Give it a `name`, such as **2-inch Check-In Labels**.
    Then enter the label size for the
    appropriate labels you are using.

    - For 2-inch labels, the `Width` is `3.00 in` and the `Height` is `2.00 in`.
      The `Exposed Liner Width` should remain `0.05 in` in for `Left` and `Right`.
    - For 1-inch labels, the `Width` is `3.00 in` and the `Height` is `1.00 in`.
      The `Exposed Liner Width` should remain `0.05 in` in for `Left` and `Right`.

    .. figure:: https://i.tpsdb.com/hope.1212141145.EditStock.jpeg
        :target: #

Step 4
    Click `OK` when you are finished.
Step 5
    Click on the `Stock` tab.

    - Uncheck the box for `Use Current Printer Settings` in the bottom section called
      `Position Adjustments`.
    - Change the `Stop Position` to `0.70 in`.

      .. note::
        If your printer has a cutter installed, set the `Stop Position` to `1.06 in`.
        Also, set the `Post-Print Action` to `Cut` in the `Media Handling` section.
        Set the `Occurrence` to `After job`.

    .. figure:: https://i.tpsdb.com/hope.1403191447.Godex_Stop%20position.png
        :target: #

Step 6
    Click `OK` when you are finished.
Step 7
    Click `Apply` and `OK` on the `Printing Preferences` box.

|
|

+--------------------+------------------+
| **Latest Update**  |   **02/28/2024** |
+--------------------+------------------+

Added link to Check In Print Server article